Тюнер Amiko 8900
На экране BOOT
HyperTerminal при загрузке выдает
Board: STx7111-Mboard (MB618) [32-bit mode]
info: Disregarding any EPLD
U-Boot 1.3.1 (Nov 15 2010 - 17:57:53) - stm23_0043 - YW 1.0.018 Rel
DRAM: 128 MiB
NOR: 8 MiB
NAND: 512 MiB
In: serial
Out: serial
Err: serial
IdentID : 09 00 0a 00 00 c6 c3
Hit ESC to stop autoboot: 0
## Booting image at a0080000 ...
Image Name: Kernel-Ramdisk-Image
Image Type: SuperH Linux Multi-File Image (gzip compressed)
Data Size: 5867346 Bytes = 5.6 MiB
Load Address: 80800000
Entry Point: 80801000
Contents:
Image 0: 2970083 Bytes = 2.8 MiB
Image 1: 2897250 Bytes = 2.8 MiB
Verifying Checksum ... OK
Uncompressing Multi-File Image ... OK
STM-GMAC: Unable to find a PHY (unknown ID?)
stb_id = 90a00c6c3
Loading Ramdisk to 80d3c000, length 002c3562 ... OK
Starting kernel console=ttyAS1,115200 rw ramdisk_size=6144 init=/linuxrc root=/d
ev/ram0 ip=192.168.0.69:192.168.3.119:192.168.3.1:255.255. 0.0:lh:eth0
ff stmmac
eth=msglvl:0,phyaddr:1,watchdog:5000 bigphysarea=4000 nwhwconf=device:eth0,hwadd
r:24:00:0A:00:C6:C3 Manufacture=Spark-Project STB_ID=09:00:0A:00:00:C6:C3 - 0x00
53d000 - 2897250 ...
востановительной прошивкой шьется , конденсаторы поменял , помогите разобратся .