WINQUEST HD Micro+

[ueh3015]

Serial Port Opened
monitor start
download start
Please reboot the STB manually.
Change baudrate to 115200.
monitor stop
Sync Succeed.
Sending boot init...
Send boot init completed.
boot init run successfully.
SendClient.
Sending Client is complete.
Client is up.
Client Functionality is good.
uboot run successful
download successful!
monitor start
usb start;fatload usb 0 83000000 users12.bin;sf burn 83000000 0 400000;
(Re)start USB...
auto_detect_usb_port --- usb default sel port 1
port_sts0:0x00000803 port_sts1:0x0c000000
auto_detect_usb_port --- usb sel port 0
USB: usb_debug
need usb0 plug in....
usb0 device connect port status :0x1803
port0 reset down port status :0x8001205
ehci_hcd_init...
Register 10011 NbrPorts 1
USB EHCI 1.00
scanning bus for devices... . 1 Storage Device(s) found
scanning bus for ethernet devices... 0 Ethernet Device(s) found
reading users12.bin

4194304 bytes read
do_spi_flash_uboot_save offset[0] len[400000]
phy_clk = 405, clk=50
R_SPIN_CH0_BAUD: 40000009
SF: Unsupported This flash[20 4016 2040]

exception_handler: excp_evt=0x4

0x04-address error (load or instruction fetch), errorepc=0x90109cf4


Count=0x6075ddde, Compare=0x601d8c35
BadVAddr=0xffffcf85, EPC=0x813d7f44
Cause=0x40804010, status=0x11001303
EBase=0x8140c000, IntCtl=0xd4000200

exception_handler: because of exception, enter into dead - loop