Универсальное ПО для Т2 ресиверов на процессоре GX3235S

[undergroundz]

В общем ничего не помогает от ошибки, прошил без изменения фронтэнда

Лог изменился:

error : configure DAC must set ENABLE_GX_OTP = y !

Partition Version : 102
Partition Count : 6
Write Protect : TRUE
CRC32 Enable : TRUE
Table CRC32 : 11164962
================================================== ============================================
ID NAME FS CRC32 START TOTAL_SIZE MAIN_SIZE USED_SIZE Use% RES_SIZE
================================================== ============================================
0 BOOT RAW 1D93CCAF 00000000 128 KB 128 KB 101144 B 77% 0 MB
1 TABLE RAW 00020000 512 B 512 B 512 B 100% 0 MB
2 LOGO RAW 659617FD 00020200 65024 B 65024 B 58238 B 89% 0 MB
3 KERNEL RAW EF2CEA17 00030000 2624 KB 2624 KB 2560 KB 97% 0 MB
4 ROOT CRAMFS DE112DBA 002c0000 896 KB 896 KB 800 KB 89% 0 MB
5 DATA MINIFS 19635C01 003a0000 384 KB 384 KB 1 B 0% 0 MB
----------------------------------------------------------------------------------------------


GxLoader v1.9.6-x 20170220

cpu family : CSKY
chip model : gx6605s
board type : 6605s
memory size : 64 MB
Flash type : w25q32
Flash size : 4 MB
warning: board-init not call function enable_dac, will open cvbs & ypbpr default.
show jpeg logo ...

USB0: USB EHCI 1.00
scanning bus 0 for devices... 1 USB Device(s) found
No device found. Not initialized?
EHCI failed to shut down host controller.
USB0: EHCI fail to reset
lowlevel init failed
USB error: all controllers failed lowlevel init
usb_init failed
romfs_load file ecos.bin.lzma.

Decompress kernel ...ok

The total boot time is: 10 s (10584 ms)

cmdline str: mem.
mem_info bank[0]start:90000000, size:1800000.
mem_info bank[1]start:91800000, size:2800000.
The whole mem size: 4000000.
wdt_init, 6605.
-----------[bsp_panel_mod_init] ret = 0----------
-----------[bsp_gpio_mod_init] ret = 0----------
jedec_id=ef4016, ext_id=0
---jedec_id=0xef4016-----
___usbwifi_init____
usbnet dev supported!
[cyg_net_init] Init: mbinit(0x0)
[cyg_net_init] Init: cyg_net_init_devs(0x0)
cyg_net_init_devs Init device 'ra0'
___rt_ecos_init____
cyg_net_init_devs Init device '/dev/eth1'
cyg_net_init_devs Init device empty '0x9068a598'
[cyg_net_init] Init: loopattach(0x0)
[cyg_net_init] Init: cyg_ppp_pppattach(0x0)
[cyg_net_init] Init: ifinit(0x0)
[cyg_net_init] Init: domaininit(0x0)
[cyg_net_init] Init: cyg_net_add_domain(0x905fade8)
New domain internet at 0x0
sack hole zone : 0x90718ff0
[cyg_net_init] Init: cyg_net_add_domain(0x905faa98)
New domain route at 0x0
[cyg_net_init] Init: call_route_init(0x0)
[cyg_net_init] Done
USB HCD: device gx-ehci, build at 14:45:13 Jul 17 2019
ehci: 0x9090fa4c
ehci->hcs_params=0x2112, num: 2
hcs_params=0x2112
flag=0x0.
hub1=0x2000
hub2=0x2000
ehci base=0xa0900000
operational base= 0xa0900010
gx-ehci gx-ehci.0: gx EHCI
gx-ehci gx-ehci.0: new USB bus registered, assigned bus number 1
ehci_qh_alloc, cross 4k boundary, just throw qtd: 0xb091bf80
ehci_mem_init():ehci->async->qh_dma=0x1091c000
ehci_mem_init():sizeof qtd: 96.
ehci_mem_init():sizeof qh: 128.
gx-ehci gx-ehci.0: supports USB remote wakeup
gx-ehci gx-ehci.0: irq 59, io mem 0xa0900000
<6>gx-ehci: ehci_mem_cleanup err.